Tuesday, January 3, 2017

January 1-2 2017 Update: lower side skins

January 1: Continued work on riveting structure, right lower side skin attached.   Riveted F-01412 bulkhead to aft bottom   skin and attached this skin to the remaining structure.  
January 2: Extensive riveting (mostly backriveting) of skins to bulkheads.   Used MK-319-BS and MK-321-BS in some areas where reach of the called out rivets made for smaller shop heads or rivets were very hard to buck.  A few "oops" rivets needed and a couple of skin dings where rivet partner   (KLB) and I miscommunicated.




-->



at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

 

  • Synergy Air Fundamentals Class
    I attended Synergy Air's fundamentals class on September 10th.  Completed a practice project.  This was a very good learning experience...
  • Installed Archer VOR/ILS antenna in the right wingtip
    I decided to go with Archer antenna for VOR/ILS - installed in the right wingtip.   I had to remove 5 nutplates, match drill antenna to fit...
  • January 18th Update
    Got quite a bit done.  First, I've been cleaning up wiring, putting shrink wrap over wires where they might chafe, adding cable ties, j...