Started prepping parts for this section - separated parts with bandsaw, sanded and used Scotchbrite wheel to deburr, then deburred further with rubber abrasive cones on Dremel tool.
Subscribe to:
Post Comments (Atom)
-
I attended Synergy Air's fundamentals class on September 10th. Completed a practice project. This was a very good learning experience...
-
I decided to go with Archer antenna for VOR/ILS - installed in the right wingtip. I had to remove 5 nutplates, match drill antenna to fit... -
Progress is slow right now thanks to work travel interrupting my airplane building. I've been working on avionics. Finished the cent...
No comments:
Post a Comment