Friday, March 10, 2017

March 9-10: Empennage fairings and fitting rudder offset tabs.

March 9:


Finished sanding R Elevator cap, primed this and fitted to elevator.  Riveted in place.  

March 10:

Primed empennage gap fairings.  Fabricated rudder stop offset tabs, primed these, match drilled them to rudder horn, and riveted in place.  Filled gaps on top surface of right HS and elevator tips, sanded.  
at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

 

  • Synergy Air Fundamentals Class
    I attended Synergy Air's fundamentals class on September 10th.  Completed a practice project.  This was a very good learning experience...
  • Installed Archer VOR/ILS antenna in the right wingtip
    I decided to go with Archer antenna for VOR/ILS - installed in the right wingtip.   I had to remove 5 nutplates, match drill antenna to fit...
  • Working on avionics
    Progress is slow right now thanks to work travel interrupting my airplane building.   I've been working on avionics.  Finished the cent...