Yesterday my friend Andy Grimm came over and helped me fit the lower half of the cowling. On & off a BUNCH of times, taking small amounts of material each time. After a few hours we had it "good enough". Last night I started drilling all the hinges, and finished that today.
Initial fitting of bottom cowl:
Taping between rivet hole locations:
Drilling hinges:
Fitting the front tabs for the two side hinges:
Final fit of side hinges:
Notch for hinge tab:
Initial fitting of bottom cowl:
Taping between rivet hole locations:
Drilling hinges:
Fitting the front tabs for the two side hinges:
Final fit of side hinges:
Notch for hinge tab:
No comments:
Post a Comment