Saturday, February 11, 2017

February 11, 2017: drilled elevator horns, attach HS to tailcone

-->
Drilled the elevator horns, first through the center flange bearing then after securing both elevators through the bearing with hardware, drilled the lower part of the horns.  Attached horizontal stabilizer to tailcone, drilled 4 aft spar holes to 1/4", secured HS to tailcone with hardware.  Attached VS to tailcone in preparation for attaching rudder.









at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

 

  • Synergy Air Fundamentals Class
    I attended Synergy Air's fundamentals class on September 10th.  Completed a practice project.  This was a very good learning experience...
  • Installed Archer VOR/ILS antenna in the right wingtip
    I decided to go with Archer antenna for VOR/ILS - installed in the right wingtip.   I had to remove 5 nutplates, match drill antenna to fit...
  • Working on avionics
    Progress is slow right now thanks to work travel interrupting my airplane building.   I've been working on avionics.  Finished the cent...