Sunday, February 5, 2017

February 4, 2017: final riveting top skins


With help from Max:  placed moving blankets on shop floor and moved the tail cone to this area.  Then I used built-up moving blankets and floor mat material to "bridge" all the bulheads, finally putting a foam mattress pad in place so I could crawl into the tail and back rivet the remaining rivets in upper skin.  Turned out very good.  Did some prep for Section 11.  SECTION 10 COMPLETE (FINALLY)




No comments:

Post a Comment

Panel nearly done, starting work on cowl baffles

I spent most of the time since last post finishing up wiring for panel, installing panel screens (G3X and G5), installed transponder antenn...