Sunday, February 26, 2017

February 22-25: Work on fiberglass fairings rudder, VS, HS, elevators

February 22:

Bonded tail light mount to rudder bottom fairing

February 23:   

Sanded and prepped fiberglass tips for HS, elevators, VS, and rudder.  Used 80 grit for high spots, 220, then wet sanded with 400 grit.  

February 24: 

Installed rudder top fairing, left elevator fairing, and drilled/clecoed right elevator fairing
February 25:

Completed install of right elevator fairing.  Completed install of rudder bottom fairing including touching up primer.  Laid up fiberglass for VS top fairing and both HS tip fairings.








at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

 

  • Synergy Air Fundamentals Class
    I attended Synergy Air's fundamentals class on September 10th.  Completed a practice project.  This was a very good learning experience...
  • Installed Archer VOR/ILS antenna in the right wingtip
    I decided to go with Archer antenna for VOR/ILS - installed in the right wingtip.   I had to remove 5 nutplates, match drill antenna to fit...
  • January 18th Update
    Got quite a bit done.  First, I've been cleaning up wiring, putting shrink wrap over wires where they might chafe, adding cable ties, j...