Friday, February 17, 2017

February 15, 2017: Rudder bottom fairing


Cut the rudder bottom fairing along scribe line then fitted it to the rudder following steps in Section 12.  Drilled per the plans on each side, then used the nutplate jig to drill for nutplates on the bottom of the rudder.  



at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

 

  • Synergy Air Fundamentals Class
    I attended Synergy Air's fundamentals class on September 10th.  Completed a practice project.  This was a very good learning experience...
  • Installed Archer VOR/ILS antenna in the right wingtip
    I decided to go with Archer antenna for VOR/ILS - installed in the right wingtip.   I had to remove 5 nutplates, match drill antenna to fit...
  • Working on avionics
    Progress is slow right now thanks to work travel interrupting my airplane building.   I've been working on avionics.  Finished the cent...