Since last post have been jumping around a bit. Still waiting on some re-fit of fuel and oil lines to finish up install of fuel servo and snorkel. Installed control cables to panel, completed the prop control cable - waiting to finish the throttle/mixture when servo install done. I've gotten all the wires through firewall, cleaned up wiring under the panel/subpanel, and connected the sensors forward of the firewall, and the top spark plugs. I'm using Deutsch DTM connectors and service loops for all the sensors.
I had to do some inventive bracket fabrication to stabilize the manifold pressure hose.
Also got the manifold pressure hose connected to PMAG. And more little stuff. FWF is starting to look more complete. Still lots to do of course....
Upper plugs 1 and 3:
Control cables in place:
Cleaned up wiring:
Prop governor control:
I had to do some inventive bracket fabrication to stabilize the manifold pressure hose.
Also got the manifold pressure hose connected to PMAG. And more little stuff. FWF is starting to look more complete. Still lots to do of course....
Upper plugs 1 and 3:
Bracket for manifold pressure line and sensor wiring right side:
Battery / alternator cables, ANL fuses, ammeter shunt, sensor connections on left side.
Left side firewall pass-through. Sealed it because I can't add any more wires here. I did put a couple of spares in place for any future needs.
Cleaned up wiring:
Prop governor control:
No comments:
Post a Comment