| Completed prep and primed all parts for right elevator. Completed riveting of left elevator including trailing edge and close out tab. Completed sections 9-14, -15, -16 for right elevator. Using MK-319-BS rivets for attaching skins to rear spar, much easier and less bending of skins than using the special bucking bar. Ordered more to have adequate quantity. Also ordered more 3-3 rivets for skin to ribs (not enough to completed bottom and top skin back-riveting. |
Monday, November 21, 2016
November 20, 2016: right elevator parts prep, priming, complete riveting left elevator
Subscribe to:
Post Comments (Atom)
-
I attended Synergy Air's fundamentals class on September 10th. Completed a practice project. This was a very good learning experience...
-
I decided to go with Archer antenna for VOR/ILS - installed in the right wingtip. I had to remove 5 nutplates, match drill antenna to fit... -
Progress is slow right now thanks to work travel interrupting my airplane building. I've been working on avionics. Finished the cent...
No comments:
Post a Comment